1、安裝別墅護欄時應事先對安裝環境進行查看，再設計出相對應的安裝圖稿，選擇相對應材質的別墅護欄。
       2、支柱埋設時，應將柱子打入到設計圖中所指示的地方。在無法打入柱子的地方，應開挖設置柱子的柱坑，開挖凈深應達到設計圖中所指的地方?；靥钔脸怯衅渌幎?，否則應采用良好的材料分層填筑夯實。
       3、在鋪筑水泥混凝土、瀝青混凝土或其他預拌瀝青材料的地面設置支柱時，柱坑應回一點點，余下部分用相同的路面材料回填并壓實，應達到監理工程師填到路面面層以下的滿意。
       4、柱子不應由于采用打入法而引起可見的變形?？梢栽儆玫膿p壞的柱子，需冷鍍鋅化合物。
       5、別墅護欄拼合接頭的安裝應符合相應的規范要求，不得馬虎隨意任之。
       6、鑲板的安裝，不應出現損壞，及時修理。

1, install the villa guardrail should be prior to the installation environment view, to design a corresponding installation drawings, choose corresponding material villa guardrail.

2, support embedding, infiltrate pillars shall be indicated in the design drawing. Where can't into the pillars, set the pillars of the column should be excavation pit, net deep excavation should be reached design referred to in place. Backfill unless there are other rules, otherwise should use good filling cement materials.

3, in paving cement concrete, asphalt concrete or other ready-mixed asphalt materials ground set pillar, column pit should be back a little bit, the rest of the road surface with the same material backfill and compaction, should reach supervision engineer to fill in below the surface in satisfaction.

4 pillars, should not be visible due to the scoring method of deformation. Can again with the damage of the pillars of cold galvanizing compound.

5, villa guardrail splice joint installation should comply with the relevant specification requirements, subcontractor shall not be careless at random.

6, the installation of the panel, should not appear damaged, repair in a timely manner.